Posted on

marijuana seed germination rockwool

However, healthy soil doesn’t just contain organic substances. Vital minerals and elements required by plants are inert by nature. Some of these are locked away inside of Rockwool and will eventually end up inside your cannabis plants, where they’ll enable and support key physiological functions.

Rockwool is a great medium for growing marijuana. You can take your strain of choice through the whole cannabis life cycle with rockwool. Growers of all levels, using a variety of hydroponic setups are harvesting heavier yields a whole lot sooner. It’s about time you tried rockwool too.

Is Rockwool Reusable?

1. Fill up a shallow bowl with water and test the pH. Add your pH-down product until your meter shows an acidic reading of 5.5.

Rockwool cubes are sterile and inorganic. After being exposed to extreme heat, Rockwool arrives at a grower’s doorstep clean and ready for use. Because it doesn’t contain any organic matter, Rockwool helps to protect the root zone against damaging microbes.

Finally, the dense sheets enter a large oven. The heat activates the binding solution and enables the wool fibres to hold their shape.

Options for starter cubes are seemingly endless, but the majority are made of either rockwool or peat.

Rockwool Cubes are designed to maintain the correct water to air ratio and squeezing them may damage their structure. Some of the marijuana forums advocate doing everything from squeezing them completely dry, all the way to flinging them around like paintbrushes in order to get excess water out. None of that is necessary, leave it as it is. It will stay moist for several days without needing to be watered this way as well.

Best Way To Germinate Weed Seeds

So what is the best way to germinate weed seeds? Read on to find out…

After examining each method, if you absolutely had to pick one, it would be starter cubes and seedling plugs.

They should look like this:

3 days. Once the first true leaves emerge, we want to select for the strongest one (the one that grew the tallest), and cut off the tops of all other seeds that are growing next to it. Do not pluck them out, as you may uproot it’s neighbors. Simply cut it off as close to the hole as you can without messing with the stronger one that you plan on keeping alive.

If you put more than one seed in your cube (just in case one didn’t make it), than you probably have several seeds sprouting up in each cube at the end of

On top of that, Rockwool is like asbestos, you don’t want to be squeezing it or breathing it or generally touching it any more than you need to. Here is a good article on some of the health concerns of Rockwool. I use it because it is what works best, but be cognizant to the fact that it is a potentially dangerous substance to be making contact with so don’t do anything more than you need to with it.

Important: Do not let the PH of the water go below 5. A Ph this low will damage the fibers of the Rockwool Cube

To accomplish this, use either Ph down chemicals, or lime juice (as it’s acidic). Add these to the water in small increments (VERY SMALL), and test the water to see where the Ph is. Continue doing this until you have a Ph of 5.5-6.

Now that we have the Ph adjusted water, it’s time to stabilize and hydrate the Rockwool cubes in it. Insert the Rockwool Cubes into your container and let them soak for roughly 1 hour. Once the hour is up, the cubes will be big and fat with water. Take them out of the bowl of water and put them somewhere you don’t mind getting a little wet. Save the remaining water for step 3.

Using either a PH test kit or a Ph meter, determine the Ph of the water. Water comes out pretty alkaline, usually around 7.4, so you will need to acidify it a little bit to bring that Ph down to the desired level. Aim for as close to a Ph of 5.5-6 as you can get.

They should look like this: