Posted on

how to seed process in aerogarden for marijuana plants

The setting of grow light is done after selecting an appropriate icon. When the producer has auto-flowering seeds with him/her, the experts would recommend 20/4 light cycle. The setting would follow the following guidelines – Open of light is a 6 in the morning and putting down of the lighting will be done at 2 in midnight.

Aerogardens are normally used in the most production process of Marijuana as an intimidating one. Most of these producers use these for germinating the seeds. After that, the whole thing is transferred to larger hydroponics system. These larger systems allow more heights for the plants and grow lights are also offered. Such transference is done at the age of 2 to 5 weeks. In the larger hydroponics, larger reservoirs are provided for the roots to expand. Better quality buds are also produced at this point with support from the powerful lighting. Despite these, experts have little doubt that the best breeding center for marijuana is the Aerogarden.

The Methods

The first germination will see the sunlight after a lapse of 4 days afterwards.

The nutrients for seed hygiene should be set for each period of seven days. At the end of every week, the inbuilt alarm system within would inform about replacing the water and addition of nutrients.

Limitations in design are thus pointed out by some critics. However, there are various segments in such critics. While a group is pointing towards lesser powerful lights thus conceding in the level of production – another group points out to the maximum height limitation for the grow lights. The light hoods extend around 24 inches for some models while others brood for lesser heights. Besides, small reservoirs are bound to overgrow with root mass. This is due to the fact that with the passage of time, the volume of roots will bulge by consuming water.

I usually cut above the third node and later, I cut the secondary branches as well to get a flat canopy and better control of the global shape. Topping help to multiply buds sites and improve light dispersion.

On this page, you will learn all you need to know to grow medical marijuana in your AeroGarden™ during the vegetative stage!

The LED panel does not heat that much, and when lights are off, the temperature should not drop more than one or two degrees. In the night period, don’t let the temperature fall below 18°C (64 °F).

4. Growing techniques (optional)

In the vegetation period, humidity level should be between 40% – 65%. Higher relative humidity level can lead to fungus problems while lower humidity can lead to smaller plants and lower yields.

With feminized seeds, you should cover the control panel to avoid any light leak on the night period during the transition. This may delay the flowering process, so make sure there are no light leaks during the 12 hours of darkness.

In the vegetative stage, you should run on an 18/6 light cycle. After 3 to 4 weeks, when the plant has enough nodes (5 +), you switch to 12/12 to initiate the flowering stage.

After successfully germinated your seeds, it’s time to take care of them! Controlling humidity, temperature, pH, while feeding your plants, (without giving too many nutrients), are crucial steps at this stage.