To create a dark, protected space, take another plate and flip it over to cover the seeds, like a dome.
Germination is the process in which a seed sprouts and begins to grow into a new plant. Also referred to as “popping,” germination is the very first step in starting your weed grow.
Autoflowers don’t need lots of nutrients because they’re small and don’t spend much time in the vegetative cycle. They won’t need as much veg nutrients—such as nitrogen—but will need more bloom nutrients.
Cultivating males is important for breeders trying to cross new strains and genetics, but most people growing for buds will want to remove the males.
This is the beauty of seeds—often, you can tell which plants or genetics will thrive right from the get-go. This will help you determine which plants you want to take cuttings from for clones or for breeding if you want to create a seed bank of your own.
Because only female cannabis plants produce buds and you want them to focus all their energy on producing buds and not seeds, it’s important to identify and get rid of male weed plants so they don’t pollinate females. If females are pollinated, it will give you buds filled with seeds, making your weed harsh and unpleasant.
Additionally, every long-time grower will tell you that clones degrade over time.
Marijuana seedlings are very sensitive to light, and therefore you should ensure that you provide just the right amount of light. If grown outside, seedlings should be provided with direct sunlight. If inside, provide them with half a day of sunlight through a sunny window sill.
We like to use seedling pellets that are made of a mix of compressed peat moss and coco husk. To expand, soak it in water for 10 minutes. Once your seedling pellet has absorbed enough water and has expanded to its maximum size, drain off any excess water. The growing medium should be like a damp sponge that would not leave streaks on the table. Dig a small hole about 1/4 in deep for your seed. Use a spoon to lift the seed out of its bath. If it has popped out a taproot be careful not to damage it. Gently place the seed into the hole and lightly cover it with dirt from the pellet. Now that you have started the germination process, your seedling will come above ground within two weeks. The older the seed, the longer it takes for it to germinate.
Now bury it on top of the rooting pack so the base of its stalk is level with the top soil. Give it a proper watering to set the roots in the ground, then skip your next watering so the roots can take hold.
Raising a seedling, however, requires some patience, gentle hands, and a smidgen of luck. Thankfully pot seeds are remarkably vigorous because they are what’s called endosperm seeds, which means they have almost pre-formed cotyledon leaves before you even add water. Below is a brief guide on the techniques we have found yield the most success when starting seeds and raising your seedling to a healthy plant ready for transplanting.
Cultivating marijuana plants from a seed rather than a clone can be quite exhausting since it requires a lot of care for the plants to germinate. There are some good practices that you should undertake before planting a seed to ensure maximum germination. First, you should start by soaking your seeds in container containing lukewarm water in a dark environment for 12-24 hours. Soaking the seeds accelerates germination by softening the outer shell. During planting, use seedling pallets soaked in water for 10 minutes. Place the seeds in a small hole ¼ in deep and then gently cover with dirt from the pallet.
We hope this guide helps you find fun and success with your plant. If you have any questions, please comment below. Check out our kits here if you’re ready to get started.
The first set of leaves to come above ground are called the cotyledons. These little leaves are packed with energy and will grow to about 1/4 in in size before eventually falling off. Your second leaves to emerge will be single blades and look like regular pot leaves.