Posted on

germinate old marijuana seeds

As cannabis seeds age, their protective outer shell hardens and prevents water from passing through. Unless the tiny, dormant embryo that lives inside the shell detects moisture, it doesn’t know that the conditions are right to sprout. As a first step, pre-soak your old cannabis seeds for about 12 hours to see if that does the trick.

The older a cannabis seed gets, the harder it is to pop. But hard doesn’t mean impossible. If you’ve been saving your seeds for a rainy day and it finally started pouring, these tips could help you get most, if not all, of your old beans to germinate.

1. PRE-SOAK WITH SUPPLEMENTED WATER

To improve your chances, use carbonated water and/or add one of these supplements that help with water absorption. Fulvic acid and most boosters also give your seeds a light dose of nutrients.

Keep the water warm, but not too hot. Aim for around 22°C. Avoid direct sunlight, and keep an eye on the glass. Do not soak seeds for prolonged periods, more than 24 hours can deprive them of oxygen and make them drown.

Scarification, or scuffing the shell, can also help water pass through an older seed’s tough outer shell.

If this isn’t enough, you can try carefully (and very gently) using a sharp knife like a Stanley blade to remove the ridge running along the middle of each seed. This should expose the inside of the seed a little, helping it absorb moisture and, hopefully, giving it a better chance of germinating.

1. Place 2 pieces of paper towel inside a salad plate.
2. Dampen the paper towels and place your seeds on top of it.
3. Cover the seeds with another 2 pieces of damp paper towel, then cover the salad plate with another plate, and keep it in a warm, dark cupboard.
4. Check on your seeds every 2–3 days.

• Some seeds won’t germinate at all. Unfortunately, old seeds sometimes just don’t sprout. So, if you try all of the tips below and wait patiently without any luck, it’s likely your seeds are just too far gone.

TRY GERMINATING YOUR SEEDS IN CARBONATED WATER

Try dropping your old seeds into a glass of sparkling water. The CO₂ in the water should help the seeds absorb more moisture, encouraging them to sprout. You can also add some fulvic acid to the water to help break down the shell of your seeds. You’ll only need about 2.5ml of acid for a glass of sparkling water (roughly 250ml).

One of the main reasons old cannabis seeds don’t germinate is because they tend to have a very hard outer shell. Now, cannabis seeds naturally have a hard shell that helps protect them until the conditions are right for them to germinate. Over time, however, this outer shell can become so hard that it inhibits the seed from germinating altogether.

Did you find some old seeds in a forgotten corner of the house? Well, you’re in luck; below we’ll share some simple tips to help you germinate old cannabis seeds.

This is a very popular way to germinate seeds. And for good reason; it’s pretty successful. Here’s how to germinate your cannabis seeds using paper towel:

Although the seeds have taken some time inside storage containers, ripe weeds seeds’ hardness is not compromised. Hard and tough seeds with a smooth shell guarantee a reasonable degree of germination. Also, pay attention to wavy and cracked seeds. They will lose time and energy and will not germinate after planting.

Whether we obtained the seeds from a seed bank, a store, or a retailer, different cannabis seed strains have different colors. Mature cannabis seeds acquire a dark coat, while immature ones are brighter and usually white. The most visible colors are brown, tan, and sometimes black. In contrast, bright yellows and whites quickly identify immature seeds.

Ways to Germinate Old Cannabis Seeds

In addition to chemical and mechanical scarification, we can use other DIY methods to loosen seeds. For example, we can use a small knife to scratch or open the seed coat. We can explore different approaches as long as we do not damage the seed embryo.

To use a mixture of hydrogen peroxide for the germination process, use 1 to 2 drops of 99% hydrogen peroxide in a glass of water. After soaking for 24 hours, the outer shell is softened enough to germinate the seeds.

The first step in any farming process is to make sure we have the right seeds, and the same goes for weeds. When harvesting autoflowering marijuana seeds, everything is preserved, and nothing is lost. This means that all types of seeds are ripe and immature. How do we distinguish good seeds from bad ones? You are considering the following.