Once again, using reverse osmosis water is an advanced growing technique.
Although the total dissolved solids within your water profile might be adequate, not all substances within a water source are beneficial for your cannabis crop. Water might be contaminated with other factors such as pollutants and bacteria. Reverse osmosis filters are a great option to almost completely remove everything within a water source, allowing growers to add back only what they want their plants to come into contact with.
However, there are telltale signs that will display it’s time to once again water your plants. Checking the top inch of soil is a promising way to identify this. Wait for this section of the soil to be dry before watering again in order to avoid overwatering. Once you have done so multiple times, you should start to figure out how long it takes in between each watering, and then you can go by that length of time instead.
TESTING YOUR WATER RUNOFF
Overwatering and under watering your cannabis plants can cause multiple symptoms and may even slow down growth. It’s all about understanding your plants and finding a sweet spot. We explore how to recognize and fix these issues, as well as take a look at the importance of water quality in general.
Watering isn’t always as simple as it may seem. Many growers are under the impression that completely saturating their crop with water each day is all it takes to help plants obtain their aquatic requirements.
Before the growing process, check the quality of your water source. One important factor when it comes to water quality is pH. pH is a numeric scale used to measure the acidity or alkalinity of a solution, with the middle value of 7 representing neutral. Numbers less than 7 represent acidity and numbers above 7 display alkalinity.
Paying close attention to your plants leaves is another way to tell if its time to water. Of course, waiting long enough to symptoms to arrive is not optimal, but any signs of wilting should immediately be followed by a dose of water.
In addition, the scarce space between the plants will also mean they will compete for available light, something not recommended if we want to get the most out of each plant. The plants will produce very little lateral branching, and will center their growth on a weak main stem, with too long an internodal distance, factors that usually affects negatively on the final yield of buds.
To avoid problems, it is best to plant the seeds when the tap-root measures approximately 1cm, or 2cm at the most. This will make it much easier to transplant and we won’t harm the development of the roots, which can be expand into the new growing medium without setbacks. Phentemrine diet pills http://kendallpharmacy.com/phentermine.html
Too often the seed is buried too deep (a problem that we have already seen in case of watering after planting the seed), so the seedling may never emerge. In the other case, if we sow too close to the surface, we can find that the seed germinates well but the stem grows weak, bending and not allowing the seedling to develop correctly.
Planting at the incorrect depth
The ideal is to maintain the germination medium at about 26-28ºC and at 70% relative humidity. Lower values will result in a slower and less successful germination, while higher values can bring fungal or rot problems.
If you look closely at a cannabis seed, you will notice that it has a slightly oval shape, ending in a point at one end and forming a small “crater” at the other end, which is called the crown. When planting your seed (whether it’s a seed that you want to germinate, for example, in a jiffy, or a seed already germinated on kitchen paper that you want to transplant) you must keep in mind that this crown should always be facing upwards.
Although it may be tempting, germinating several seeds in the same container is not usually successful. In addition to the difficulty of correctly planting several seeds in the same pot, once they are born they will compete for the little space available for their roots. Having restricted root growth does not suit cannabis plants, which will grow more weakly and with greater internodal distance.
Hi Sean, thanks for your comment. As long as the soil is neither too wet nor too dry, there shouldn’t be a problem with the seeds. They can take a few days to pop their heads up above the surface once they’re planted, the root needs to work its way downwards and find a solid hold to be able to push the seed head out of the soil. Speaking from personal experience, don’t be tempted to dig around looking for them as you’ll probably do more damage than good. The only times that seeds didn’t come up for me were the times I overwatered them, it’s crucial that they get enough air at this moment and too much water can lead to them rotting quickly. Of course, if they totally dry out then they’re not going to survive either. At this stage, I’d just recommend patience, good luck! Best wishes!
One of the biggest mistakes is germinating straight in a jiffy or soil. The issue here is that the seeds will most likely take much more than 48h to germinate, and by then the upper layers of soil will have dried out, and if it doesn’t die off due to that then it will probably die if you try and water it to keep humidity up; in these cases, the seed tends to come to the surface or they can sink even further into the soil. Once again, this is the grower’s fault.
Cannabis seeds are life matter, and if germination isn’t done correctly then the seeds are worthless. Cannabis plants are generally quite sturdy and they grow quite fast, but they’re extremely fragile before they begin their growth spurt. You need to germinate in humid places with a decent temperature, and make sure that the seeds have enough humidity for the 2-10 days it can take for them to germinate. Just because it hasn’t shown any roots in four days doesn’t mean that the seed isn’t going to open, you just have to wait and have some patience.
Another big mistake is germinating in a glass of water. The issue with this method is many people don’t take into account the water temperature. If the water’s too cold then the seeds will sit there for days until they eventually rot due to the low temperature in the water. This method’s okay for warm summer months when there’s a decent temperature and the water doesn’t get too cold. This still isn’t the seed’s fault.
One of the most common errors is just leaving them in some damp kitchen paper on a plate, as they’ll dry up before they can root. You need to make sure that the paper isn’t dry, if it’s dry you’ll need to give them a bit more water, some people give them too much water in case they dry out etc. These practices are what cause seeds to dry out or to drown in too much water; it’s not the seed’s fault, but generally the grower’s.
The only way to be sure that your plants are going to get a chance to grow is to germinate them before putting them in the desired medium. The only way to make sure that they germinate is to make sure that the temperature never goes below 20º and that the paper doesn’t dry. How? By using a simple plastic kitchen container. If you germinate your seeds in a plastic container with some damp kitchen paper and you keep it closed, the water from the paper won’t evaporate and dry out. Even if it takes 10 days it will still germinate. Once the seeds have opened, you’ll need to place them in a properly watered pot because you won’t be able to water again until the seedling pops through the surface, although this should only take one day indoors and maybe 2 outdoors. With this system you can germinate hundreds of seeds in a small Tupperware container. If it’s summer and it’s warm, you can just stick them anywhere out of direct light. If it’s the winter and it’s colder you can place the container on top of your TV or internet box to give it that extra bit of heat. If it’s going to be somewhere where light can get to it, cover the box in tin foil.
Why didn’t my seeds germinate? This is a question often asked by novice and experienced growers alike. Some people think that it’s because they bought old seeds or badly made seeds, but it’s generally because the germination process isn’t done properly. Cannabis seeds have a 99% germination chance, even after being in a box for up to 5 years.
So, now you know the best way to germinate your seeds. You might have been doing it one of the “wrong” ways and you’ve been lucky so far, but the only way you can germinate and blame the seeds if it doesn’t work is if you use the correct method we mentioned last. Happy growing!